![]() Press the Dirt Tank Release Button and pull away from vacuum.DO NOT operate your vacuum without these filters. Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre- and post-filters, are in place.Turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.Be sure to let it dry completely before placing back in Dirt Tank. Tap separator against inside of trash container and rinse under warm water, if necessary.Twist Cyclone counter-clockwise and pull down to remove.Press the bottom release button to empty. Hold the Dirt Tank over a trash container.We have additional maintenance videos for your machine on. Return the Dirt Tank to the vacuum by securing the bottom in place first and then pushing back until you hear a “click”.Once emptied, snap bottom back into place. Hold the Dirt Tank over a trash bin and press the Empty Button.Press the Dirt Tank Release Button and grab the handle to pull the Dirt Tank away from vacuum.When finished, replace the wand back on the vacuum by sliding into place until you hear a “click” and reattach hose to handle if needed.įor additional maintenance steps, visit.To do so, twist circular hose cuff counter-clockwise and remove from handle. The Stretch Hose can be removed from the extension wand.Push the release button to remove and attach desired tool. Clean hard-to-reach spaces with the Quick Release Extension Wand.Visit to see all the ways you can use your vacuum’s tools. Do not allow plug to whip when rewinding. Warning: Hold plug when rewinding onto cord reel. If it doesn’t fully retract at first, pull some of the cord out and press the button again.Hold the plug and press the Automatic Cord Rewind Button to slowly retract the cord. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |